Hi,

Well I have an issue with not one BUT 2 spectrum 300's. Both are dead and I think the same poieces are dead on each. One was a friends unit that I borrowed for a week 25 or so years back and liked so much I bought my own. His died last year and mine juts recently. I have heard of relatively cheap repairs on these and I have heard ya need a whole new board- which I find hard to swallow. I see two pieces minimum on each unit that need replaced. There are two bigger heat sinks on each main board and two electronic pieces are blown on the right hand heat sink as pictured...

I wonder what caused the issues on two seperate machines at approximately the same age?

Do any of you guys have names- descriptions of the parts and a source I have a call into miller but have not heard back yet

Please help.
Thanks!

I didn't find the right solution from the Internet.

References:
millerwelds.com/resources/communities/mboard/forum/welding-discussions/578659-please-help-board-issues-miller-spectrum-300-plasma-cutter

motion graphic animation